There are several options for track configurations, and Point-to-Point is one of them. The Point-to-Point track allows you to make a track for a session that is not made up of consecutive laps in a circuit formation. This track has a start and an endpoint, and optional segment gates in between.
Steps to creating a Point-to-Point Track Configuration :
1. Visit the "Add Sessions" tab from the bottom bar of the LITPro app
2. Click the "Past Syncs" button for the specific device you are using.
3. You will see a list of all of your past syncs, with a label, either "NEEDS TRACK SETUP" or "COMPLETE".
4. If your preferred session is labeled with "NEEDS TRACK SETUP" then continue with the steps below.
- 1. Click on the desired session that you're wanting to create a point-to-point track configuration for
- 2. You are now at the "Session Setup" page. On the bottom of the page, you will see four options, a red "Apply Track Config" which will apply your session connected to the config to the feed, a red rectangle with three bars, a "View Later" writing, and a light red trash symbol. Click the red rectangle with three bars.
- 3. A list of options will appear, you must click the "Create Point-to-Point Track" button.
- 4. You will be taken to a map, which will zoom in on your data. A saying will appear "START HERE" gesturing to a clear box, where you will add the start line.
- 5. You will add the start line, as the directions show, then the end line, and finally any segments in between.
- 6. Click the "save" writing at the top of the page.
- 7. Make a name for your "Point-to-Point" track configuration.
- 8. You will now be taken to the same "Session Setup" page from before, where you need to click "Apply Track Configuration" which will let you connect the session data to the track configuration. It will also give you the option to add to leaderboards or not, so choose your preference.
- Congratulations! You created a Point-to-Point Track Configuration
4. If your preferred session is labeled with "COMPLETE" then it already has a track configuration associated with it, but you can change it to a Point-to-Point Track Configuration, by following the steps below.
- 1. Click on the white bar that the track you want to change is listed in. This will take you to the "Session Settings" of the track.
- 2. Click the red square-shaped "CHANGE" button.
- 3. A white notice will appear, giving the choice of either, "Change Track Config" or "Nevermind". Click "Change Track Config".
- 4. You are now at the "Session Setup" page. Follow the same instructions as above to create and apply your point-to-point track configuration.